Before Beginning - MARESKA B1WL01 Manual De Instrucciones

EN
Installation of safety fence

Before beginning

WARNING:
THE SAFETY FENCE CAN ONLY BE INSTALLED ON A SOLID, FIRM AND, IF POSSIBLE,
THICK BASE. THE IDEAL SURFACE FOR THE INSTALLATION OF THE SAFETY FENCE IS A CONCRETE
LAYER.
• Make sure you leave enough space surrounding the pool in order to be able to work without any problems.
• The surface must be clean and dry in order to be able distinguish clearly the marks made on the surface.
• Do not begin to install the barrier if weather conditions are not optimal. You will have to use electrical devices, such as
hammer drills. Out of precaution, do not use these devices in the rain or on damp surfaces. In all cases, electrical devices
must be connected to a power socket equipped with a reverse current circuit breaker of 30 mA.
• Regardless of the terrain profile (slope, stairs, etc.), the height between the two support points must always be 1.10m after
the installation of the safety fence.
1. Establishing a starting point
Use a rope for the straight parts so that the layout is completely rectilinear.
2. Trace the 4 marks to designate the 4 poles of the first panel
Using the two opposing holes of the template provided or a measuring tape, mark the five holes of the first panel, moving
the template from the last hole marked.
Distance 100 cm
Figure 1
IMPORTANT:
IN THE CASE THAT THE FENCE HAS TO BE INSTALLED ON A BEND, THE DISTANCE
MUST BE ADJUSTED AROUND 5 MM, UPWARDS OR DOWNWARDS, IN ORDER TO ACHIEVE THE
DESIRED NET TENSION (SEE FIGURE IN STEP 3. MAKING THE HOLES).
3. Making the holes
The holes must be made with drill bit ø16. If the initial hole is made using the drill bit ø10 then it may be easier to carry out
the definitive drilling with ø16.
12