Descargar Imprimir esta página

Louisiana Grills Black Label LGV4BL Guía De Montaje página 7

Ocultar thumbs Ver también para Black Label LGV4BL:

Publicidad

Idiomas disponibles

Idiomas disponibles

12
A
13
B
13
1
1
1
1
8
9
14
PLACING THE GREASE TRAY
PARTS REQUIRED:
22
1
x
INSTALLATION:
Slide the Grease Tray into the Grease Tray Brackets on the back underside of
the Main Cabinet.
NOTE: THE GREASE TRAY IS COMPLETELY INSERTED ONCE THE FRONT OF THE
TRAY IS FLUSH WITH THE BACK OF THE MAIN CABINET.
INSTALLING THE COOKING COMPONENTS
PARTS REQUIRED:
4
x
1
x
1
x
INSTALLATION:
Insert the Water Pan into the lowest embossed grid supports of the interior
cabinet. Fill your water pan about ¾ full of water.
IMPORTANT: KEEP WATER IN THE WATER PAN AT ALL TIMES WHILE COOKING. IF
SMOKING FOR AN EXTENDED PERIOD OF TIME, MOVE WATER PAN UP HIGHER TO
ALLOW WATER TO LAST LONGER.
Next, insert the Heat Deflector Plate into the next set of embossed grid
supports above the Water Pan. Note 13A & 13B for proper placement, with the
"FRONT" facing towards the Cabinet Door.
NOTE: IMPROPER PLACEMENT OF THE HEAT DEFLECTOR PLATE WILL PREVENT
GREASE FROM FLOWING INTO THE GREASE TRAY. ENSURE THIS PART IS ALWAYS
INSTALLED BELOW YOUR COOKING GRIDS. THE HEAT DEFLECTOR PLATE WILL
CATCH GREASE AND DRIPPINGS FROM YOUR COOKS AND ALLOW FOR EASIER
CLEAN UP.
Lastly, place the four Cooking Grids in the remaining embossed grid supports
in the Main Cabinet.
The unit is now completely assembled.
CONNECTING TO A POWER SOURCE
STANDARD OUTLET
This appliance requires 110-120 Volt, 60 Hz, 250W. It must be a 3-prong grounded
plug. Ensure grounded end is not broken off before use. The control uses a 120 volt,
fast-blow fuse to protect the board from the ignitor.
GFCI OUTLETS
This unit works on most GFCI outlets, with a recommended size of 15 amp service.
If the GFCI outlet is highly sensitive to power surges, it will likely trip during the
start-up phase of operation. During the start-up phase, the igniter draws 200-700
watts of electricity which can be too much power for a GFCI outlet to handle. Each
time the GFCI trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
IMPORTANT: DISCONNECT UNIT FROM POWER SOURCE WHEN NOT IN USE.
Grease Tray (#22)
Cooking Grids (#1)
Heat Deflector Plate (#8)
Water Pan (#9)
www.louisiana-grills.com
7

Publicidad

loading

Este manual también es adecuado para:

1075110800