Publicidad
ULM202USB/ULM200USB
Controls
Model: ULM200M
Type of product: Wireless Microphone
ULM202USB/ULM200USB Controls
POWER/STATUS LED
1.
▼ VOLUME Button (Mute/volume down)
2.
▲ VOLUME Button (Power on/unmute/volume up)
3.
4.
USB connector
5.
Wireless Link Status LED
ULM202USB/ULM200USB Getting Started
1.
Connect the ULM200D wireless receiver to the "WIRELESS
ONLY!" USB connector on wireless-enabled Behringer mixers,
powered speakers or other compatible products, or to a USB port
on a computer.
2.
Press and hold the ▲ button on the ULM200M wireless
microphone to connect wirelessly to the ULM200D receiver.
The LED on the microphone will flash slowly during the
connecting sequence and will light solid once connected.
If the ULM200M wireless microphone cannot connect to a
receiver, the microphone will automatically power down after
10 seconds.
3.
Once connected, the ULM200M microphone will be set at
a medium volume. Use the ▲ and ▼ buttons to adjust
the volume
4.
A long press of the ▼ button will put the ULM200M
microphone into mute. The mute condition is indicated by
rapid flashing of the LED. If the user does not unmute within
60 seconds, the ULM200M microphone will power down to save
battery life.
5.
A short press of the ▲ button will unmute the ULM200M
microphone. If the ULM200M microphone is unmuted more
than 10 seconds after muting, it will return to the previous
volume level, if unmuted after less than 10 seconds it will be set
to the minimum volume level.
6.
Unplug the ULM200D wireless receiver to power down.
The ULM200M wireless microphone will power down 10 seconds
after the ULM200D wireless receiver is unplugged.
7.
The LED in the ULM200M wireless microphone will indicate
when the battery is low by regular brief flashes.
8.
Should the ULM200M wireless microphone become unpaired
with the ULM200D wireless receiver, the microphone can be
re-paired from the powered down state by simultaneously
pressing the ▲ and ▼ buttons and moving the microphone
to within 10 cm (4 inches) of the ULM200D wireless receiver.
The LED on the microphone will flash slowly during the
pairing sequence and will light solid once connected. If the
ULM200M wireless microphone cannot pair to the receiver it will
automatically power down after 10 seconds.
Model: ULM200D
(1)
(4)
(2)(3)
(5)
Publicidad
