Publicidad
Idiomas disponibles
Idiomas disponibles
HEATER ASSEMBLY
You will need to attach the heater cradle to the heating unit using the provided
screws and washers.
1. Using a wrench, remove the provided screws and washers from either side
of the unit.
2. Slide the heater cradle down over top the heater unit until the bottom
holes of the heater cradle and heating unit are aligned on each side.
3. Using a wrench, tighten each screw and washer through the heater cradle
and into the heating unit.
4. Ensure the screws are fully tightened and the heater cradle is tightly
secured.
www.newair.com
Heater Cradle
Heating Unit
Screw
Installation
EN
9
Publicidad
