Intenso MAGNETIC WIRELESS CHARGER MB13 Manual Del Usuario página 14

b) TWS / Smartphone
The TWS area (le昀琀) of the device can be used to charge all devices that support the Qi standard. These can
be, for example, headphones, smartwatches or smartphones. To 昀椀nd out whether your device supports wi-
reless charging via Qi, please refer to the corresponding opera琀椀ng instruc琀椀ons or contact the manufacturer.
Place your device so that the Qi area of the device is centred on the cross of the charging area. The charging
process starts automa琀椀cally, and the le昀琀 LED lights up blue.
c) Watch
The connector for your Apple Watch is located on the right side. Apple Watches as of series 3 are supported.
Simply guide the bo琀琀om of your watch over the connector and the built-in magnets will help with the cor-
rect alignment. The charging process starts automa琀椀cally and the right LED lights up blue.
If the charging process does not start, please check,
a. whether your iPhone supports the MagSafe standard for the magne琀椀c stand, whether your smart-
watch for the watch area (right) is an Apple Watch series 3 or newer and whether your headphones,
smartphone or other device for the TWS area (le昀琀) support the Qi standard.
b. whether there is a foreign object between the devices or you are using an unsuitable case.
c. whether you have chosen the enclosed quick-charge power supply or a di昀昀erent but compa琀椀ble
one. If this is not the case, replace it accordingly.
d. whether you have 昀椀rst established the power supply and only then started the charging process. If
not, please disconnect both devices from each other and unplug the power supply for a few seconds.
Then plug the power supply unit back into the socket and only then start the charging process.
e. whether the cable ends and the power supply unit are correctly connected.
Please note that the ambient temperature and the charging electronics of the device to be charged have
an e昀昀ect on the charging behaviour over which the induc琀椀ve charging sta琀椀on itself has no in昀氀uence. For
example, the charging speed can be reduced at increased temperatures or already reached charging levels,
the charging process – especially with the watch – can be brie昀氀y interrupted or brie昀氀y fail to make any
charging progress.
Step 3: End charging process
To end the charging process, simply remove your device from the induc琀椀ve charging sta琀椀on.
SERVICE/DISTRIBUTOR
INTENSO INTERNATIONAL GMBH I Kopernikusstraße 12-14 I D-49377 Vechta
Email (technical support):
Email (RMA number):
Internet:
Telephone (technical support):
support@intenso-interna琀椀onal.de
rma@intenso-interna琀椀onal.de
www.intenso.eu
+49 (0) 4441 – 999 111
(Mon. – Thur. 09:00 – 16:30; Fri. 09:00 – 14:00)
EN - Page 5 of 6