Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
1. PARTS Y COMPONENTS
Fig.1
1.
Cabinet
2.
Shelf
3.
Cold sink fan
4.
Cold sink fan cover
5.
Ventilation oles
6.
Leveling legs
7.
Upper door hinge w/ cover
8.
Door
9.
Gasket
10.
Bottom hinge
2. BEFORE USE
Remove the product from the box and remove all packing material. Make sure that
all components are included, and if any are missing or not in good condition, contact
the official EVVO Technical Service immediately.
3. PRODUCT INSTALLATION
Position your cooler so that the plug is accesible.
Keep your cooler out of direct sunlight.
Don´t place next to heat generating appliance
Do not place place directly on the ground, provide suitable stand.
The cooler will have better performance at ambient of 16-32 degrees, we suggest the
cooler be powered off if the ambient temperature is lower than 10 degree.
After plugging the appliance, allow the unit to cool down for 2-3 hours before placing
beverage into the cooler compartment.
These models use a thermoelectric cooling system with automatic defrosting system
,so there is no need to defrost manually.
The cooler must be connected to a properly earthed socket in line with relevant valid
country regulations before operating
Check the data label for voltage and frequency corresponds to your local one.
Leave a distance of 10 cm above the device and to the sides.
Do not install the device inside a cabinet or anywhere where the front of the device
cannot be seen.
14
EVVO VINOTECA VT8
Publicidad
