Publicidad
Idiomas disponibles
Idiomas disponibles
1. Twist, then pull o ff s park p lug boot.
2. Remove spark p lug from cylinder
and discard.
3. Replace with Champion
RCJ-6Y
spark p lug and tighten securely
with a3/4 inch socket wrench.
4. Reinstall the spark p lug boot.
LINE REPLACEMENT
Pre-wound
spools offer the most con-
venient
method for replacing
line and
ensuring
optimum performance.
• Replacement
spools are color-
coded to ensure
use of the correct
spool with your unit. Be sure to use
the same color spool as the existing
spool.
NOTE: Always
clear dirt and debris
from cutting head components
when
performing
any type of maintenance.
• Hold spool and unscrew cap by turn-
ing in the direction
shown on top of
the cap.
• Remove
line guide ring and spool.
NOTE:
When removing and/or instal-
ling spool, ensure dust cup remains
installed over shaft.
^
Line
Dust
bpool
guide
Cap
....
cup
t-_)1
ring
Use a pre-wound
spool or refill spool
with line. If using a pre-wound
spool,
remove tape strip from line and spool.
REFILLING
THE SPOOL WITH LINE
_WARNING:
Use only 0,080
inch (2 mm) diameter
round line.
Other sizes and shapes
of line will not
advance
properly and will result in im-
proper cutting head function
or can
cause serious injury. Do not use other
materials
such as wire, string, rope,
etc. Wire can break off during cutting
and become a dangerous
missile that
can cause senous Injury.
1. Cut a length of 25 feet of 0.080
inch (2 mm) diameter
round
Craftsman
brand line.
Feodl,ne,n
/ S S__'
_,,
,
.
dnrect_on
I I_,_ ..... _:J, I ! ....
Spool
2.
Insert one end of line into center
cavity of empty spool.
Ensure line
will feed into spool in the direction
shown on the spool (counterclock-
wise).
3.
Continue feeding line into spool,
leaving 4 - 6 inches (10 - 15 cm)
unwound
from center of spool.
INSTALLING
SPOOL WITH LINE
1. Install replacement
spool.
2.
Thread line through
line guide ring.
Line through guide ring
,,
Replacement Spool
3.
Rest guide ring on spool and place
line through slot. Allow line to ex-
tend 4 - 6 inches (10 - 15 cm)
from center of spool.
4.
Ensure line remains in slot while
screwing
cap on to the shaft.
Only tighten cap hand tight!
15
Publicidad
