Publicidad
Idiomas disponibles
Idiomas disponibles
Read the safety warnings carefully before using the appliance.
INSTALLATION
Position the appliance in the room to be dehumidified. A free
space of at least 50 cm must be left at the front of the dehu-
midifier, so as not to block the air outlet. For efficient ventilation
a space of about 5-10 cm should be left at the back of the ap-
pliance. The condensate can be drained in one of the following
ways:
a) Draining into the tank
The condensate can be drained directly into the tank. The tank
can be easily removed (Fig.1).
b) Continuous external draining
If the appliance is to be operated for long periods but you are
unable to empty the tank regularly, you are recommended to
use continuous draining.
1) Remove the continuous drain cap by turning it counter-
clockwise (Fig. 2).
2) Apply the accessory tube to the spout as shown in Figure 3.
3) Make sure the end of the hose is no higher than the spout.
Otherwise the water will flow into the tank of the appli-
ance (Fig. 4).
Make sure there are no kinks in the hose.
DESCRIPTION
(page 3)
Appliance description
A1. Control panel
A2. Condensate collection tank
A3. Lifting handle
A4. Air intake grill
A5. Dust Air filter or silver-ion air filter (on certain
models only)
A6. Air outlet grill
A7. Condensate drain hose (approx. 1 m)
A8. Anti-allergen filter (on certain models only)
A9. Activated carbon filter (only in certain models)
Control panel description
B1. ON/STAND-BY button
B2. MODE button
B3. Tank full/tank missing indicator light
B4. Dehumidification/frost protection function light.
B5. Set humidity level
(page 3 - A )
(page 3 - B )
HOW TO DEHUMIDIFY
•
Connect the appliance into an outlet.
•
Check that the "tank full/tank missing" indicator light
(
) is turned off, otherwise empty the tank or position
it correctly.
•
To turn the appliance on, press the ON/STAND BY button
.
•
Press the "MODE" (B2) button to select the desired
humidity (
,
The appliance will adjust the humidity level according to
your choice:
Approx. 60% environment humidity
Approx. 50% environment humidity
Approx. 40% environment humidity
Selecting
, the "dry" function is activated, ideal to speed up
the drying of laundry.
Please note!
•
If the humidity in the room is greater than the set
humidity, the appliance will start to dehumidify
and will stop functioning only when the desired
level of humidity is reached.
INDICATOR LIGHTS
Tank control light
(Tank control system)
This dehumidifier is equipped with a device that monitors the
correct functioning of the appliance.
The corresponding indicator light, located on the control panel,
turns on to warn the user when:
1. the tank is full:
empty the tank
2. the tank is missing:
reposition the tank
3. the tank is positioned incorrectly:
position it properly
4. in continuous drain:
the hose is obstructed or the difference in level is too great
(the water continues to be discharged into the tank)
remove the obstruction.
Once the cause has been eliminated, the light goes out and the
appliance resumes operation.
Low temperature operation indicator light
When the room temperature is too low, the electronic low tem-
perature operation device is activated. The device makes the ap-
pliance operate by alternating dehumidification cycles and fan
only cycles, thus avoiding the formation of frost. For frequent
use in cold environments, it is recommended to heat the room
7
,
,
).
Publicidad
