Descargar Imprimir esta página

cecotec CONGA ROCKSTAR 8500 INFINITY ERGOWET ANIMAL Manual De Instrucciones página 39

Ocultar thumbs Ver también para CONGA ROCKSTAR 8500 INFINITY ERGOWET ANIMAL:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
Replacing the mop
-
Remove the water tank from the vacuum cleaner.
-
Use your foot to hold the accessory against the ground and pull the vacuum cleaner
upwards until both parts are separated.
-
Replace the mop and refill the water tank.
-
Install the water tank again, insert the tank in the lower part of the vacuuming brush
head, and press until it is fixed.
5. CLEANING AND MAINTENANCE
-
Always turn off and unplug the vacuum cleaner before cleaning or maintenance. 
-
Use a soft, slightly dampened cloth to clean the surface of the appliance. 
-
Never immerse the appliance in water or other liquids. Do not allow liquids to enter the
appliance. 
-
Do not use abrasive cleaners or scouring pads to clean the device. 
-
Do not leave the vacuum cleaner in a place with direct sunlight. 
-
Do not leave the vacuum cleaner in a wet place after cleaning it.
-
After the brush has been used for a long time, bristles might start to tangle with hair and
other dirt. Clean the brush to ensure cleaning efficiency.
Cleaning the water tank and the filters
1.
Press the dust-tank release button and remove it. Fig. 10
2. Press the dust-tank release button to open the tank cover and empty it. Fig. 11
3. Use the cleaning brush to clean the filter. Fig. 12
4. Hold the dust tank, remove the filter and lift the filter cover to remove the parts inside.
Fig. 13
5. Wipe all parts with a slightly damp cloth.
6. After cleaning the filter, press the button on the display for 3 seconds to restart.
Motor filter cleaning Fig. 14
1.
Turn the filter cover counterclockwise to remove it.
2. Remove the filter and clean it.
3. It is recommended to clean the filter at least every six months.
Cleaning the brush and the vacuum head
1.
Press the release tab on the hard floor brush and remove the brush as shown in figure 15.
2. Remove hair and debris around the brush with your fingers or the cleaning brush blade.
3. Wash the brush under running water.
4. Allow the brush to dry completely before reassembly.
5. Replace the brush.
CONGA ROCKSTAR 8500 INFINITY ERGOWET ANIMAL
ENGLISH
39

Publicidad

loading

Este manual también es adecuado para:

08444