Technical Data - Biohit Midi Pro Manual Del Operador

Introduction
The Biohit Midi Pro has been carefully designed and manufactured as a lightweight, cordless pipetting
aid for use with all plastic or glass pipettes from 1–100ml.
This new Midi Pro is constructed in recyclable materials and operates on two rechargeable, long life,
environmentally friendly, 1.2V nickel metal hydride batteries. Biohit Midi Pros have uniquely formed fin-
ger triggers to minimize any high pressure points. These triggers also control intake and dispense speeds.
A battery warning light (4) is triggered whenever the charge in the batteries is low and they should then
be recharged. Pipetting with Biohit Midi Pros can also take place while the units are connected to their
chargers (5).
Midi Pro have a conveniently located slide switch (3) which allows the user to select between three
modes of operation:
Slide switch position 'High' (top)
Slide switch position 'Low' (middle)
Slide switch position 'G' (bottom)

Technical Data

Batteries 2 x 1.2V nickel metal hydride
Battery service Life 500–1000 cycles from empty
Charger 75mA/h for 14 hours plug-in; UK, European, USA,
Japanese or Australian versions
Installation (over voltage) category II
Double insulation indicated on charger by symbol
Overall weight 180g without stand
Filter (8) Hydrophobic 25mm dia 0.45µm (fitted) plus two
additional spare filters
1x 0.45µm
1x 0.20µm
Case material ASA
Nosecone material (10) ASA
Pipette holder Silicone (9)
Pipette types Plastic or glass 1–100ml
2
Midi Pro
Operator Instructions
Suction and dispense at full speed (Blow-out)
Suction and dispense at reduced speed (Blow-out)
Suction at reduced speed, dispense by gravity (To Deliver)
7. Filter adaptor
8. Filter
9. Silicone
pipette holder
10. Nosecone
6. Charging jack
Midi Pro
1. Aspirate trigger
4. Low battery indicator
2. Dispense trigger
3. Mode selection slide switch
Operator Instructions
5. Charger
3