GRE VCB15 Manual De Instrucciones página 9

lf a battery leak develops, avoid contact with the leaking acid and place the
damaged battery in a plastic bag.
lf acid comes in contact with skin and clothing, wash immediately with plenty
of soap and water.
lf acid comes in contact with eyes, immediately flood eye with running cool
water far at least 15 minutes. Get medical attention immediately.
The steps of changing the battery
(1) Push the button "a" farward along the arrow direction, until it not stuck the
slot of the connector (as picture A shown)
(2) Holding the body while reversing the connector, and removing the battery
mounting froni the body ( as "b" in picture B shown)
(3) Remove the used battery, and replace new NI-MH battery according to the
sign of positive & negative pole of the battery mounting (as shown in picture C)
(4) lnstall the battery mounting into the body (as picture D shown), pay attention
the positiva & negativa pole of the mounting (as picture "d" shown) and the 2
springs (as picture "d1" shown)alignment.
(5) Twist the connector into the body in clockwise, until the button "a" can
buckle in the slot of connector. As picture E shown.
(6) It is really important that this zone is well closed.
(7) Now you can use the cleaner according to the instruction normally.
CAUTION !
How to judge whether the battery is destroyed or the impeller is jammed?
1. The impeller suddenly is choked after it worked in a very short time. Turn off
the button, and connected the electric cleaner to the civil electricity by means
of the charger. lf the Green LED is on, it proves that the battery is destroyed
(the solution is referring to the step of how to replace the destroyed battery
group ); if the Red LED is on, start the power of VCB 15 to see whether the
impeller will be rotating or not. lf not, it proves that the impeller is jammed.
(The solution is referring to how to resolve the problem that the impeller is
jammed.)
2. The Green LED indicator is on after it is charged. Start the power, whereas
7