Publicidad
Idiomas disponibles
Idiomas disponibles
Check that all the items shown in the picture are present in the packaging: if any items are found to be missing or
damaged, do not proceed with assembly or commissioning in any way and contact your dealer to have the original
equipment restored.
1. Pull out the fixing ring halfway up the column and slide the cover (7) along the tube with the larger diameter
part facing downwards.
2. Join the base of the column to the base using the 4 screws provided.
3. Lower the cover down to the base.
4. Slide the fixing ring back along the tube with the larger diameter part facing downwards.
5. Secure the column by turning the fixing ring fully to the right.
6. Fit the motor body to the top of the column and tighten the fixing screw.
7. Place the rear grille on the motor body as shown with the handle facing upwards.
8. Secure the rear grille to the motor body with the screws provided.
9. Mount the blade on the shaft so that the screw is positioned to the rear of the blade surface, matching the
screw to the slot and tightening it.
10. Fit the front grille by fixing the clips around the perimeter and securing the screw and nut at the bottom of
the circumference.
Join the base elements and the motor body to the base as shown in the figure, then continue installation from step 7
in the previous paragraph.
FLOOR-STANDING configuration
1
Front grille
2
Blade
3
Rear grille
4
Motor body
5
Selector switch
6
Column
7
Base cover
8
Base ring
9
Base
TABLE configuration
1
Front grille
2
Blade
3
Rear grille
4
Motor body
5
Selector switch
6
Pedestal (base A + base B)
7
Nut
8
Screw
9
Hook
9
Publicidad
