Carista COBD-BT25 Manual De Instrucciones página 7

cables in the vehicle when the ignition switch is
on, as this could cause damage to the sensors or
the electronic control unit (ECU).
Do not place any magnetic objects near the
ECU. Disconnect the power supply to the ECU
before performing any welding operations on
the vehicle.
Use extreme caution when performing any
operations near the ECU or sensors. Ground
yourself when you disassemble PROM,
otherwise ECU and sensors can be damaged by
static electricity.
When reconnecting the ECU harness connector,
be sure it is attached firmly, otherwise electronic
elements, such as ICs inside the ECU, can be
damaged.
Do not expose the product to fire, explosions or
other heat sources.
Do not attempt to install, reconfigure or remove
the device from a vehicle while the vehicle is in
motion or otherwise in operation. All installation,
configuration or removal shall be done only in
stationary vehicles which are securely parked.
Attempting to service devices while the vehicle
is in motion could result in malfunctions or
accidents, leading to death or serious personal
injury.
7