Jatrhg AC-QC7000-32A-S02 Manual Del Usuario página 2

For the first use, turn the button to the right to exit the emergency stop mode:
Installation Steps of EV Charging Station on the Wall (G, H, A )
1. Turn out the three screws 2. Put the backplane H on flat wall,
connecting the backplane H to and mark the positions of four screw
the device G, and keep them holes.
aside.
4. Use a hammer to knock the
5. Pass four long screws in bag
plastic anchor in bag A into the
A through backplane H holes to
drilled holes vertically, until its
the anchors in the wall, and turn
surface flush with the wall.
them tightly.
Installation Steps of Cable Holder (F, B1, B2)
3. Use Φ6mm drill bit to drill holes
at the marked position, hole depth
about 40mm.
6. Align three holes of the device G
with holes of the backplane H, use
the original screws to connect
them tightly.
1. Put the bottom base of this 2. Use Φ6mm drill bit to drill holes
holder F on the flat wall, and at the marked position, hole
mark the positions of three depth about 40mm.
screw holes.
4. Use three long screws in bag 5. Use a screwdriver to tighten the
B1 to pass through bottom screws so that the base does not
base holes and insert into the loosen or tilt.
anchors.
3. Use a hammer to knock the
plastic anchor in bag B1 into the
drilled holes vertically, until its
surface flush with the wall.
6. Align the upper cover with the
base and press its edges to lock,
then screw two short screws in
bag B2 to ensure fixed tightly.