Phoenix STELLAR PH27QHD165 Manual De Usuario página 11

ON SCREEN DISPLAY (OSD)
SETUP
1. Input Source
a. Type-C – Select TYPE-C as Input
b. DP – Select DP as Input.
c. HDMI – Select HDMI as Input.
2. Mute: his option will allow you to open or close
mute.
3. Volume: This option will allow you to adjust the
volume.
4. Reset: This option resets all values in the OSD
back to factory standard.
OTHER
1. Aspect Ratio
a. Wide Screen – Set Aspect Ratio is Wide
Screen.
b. 4:3 – Set Aspect Ratio is 4:3
c. 1:1 – Set Aspect Ratio is 1:1
d. Auto – Set Aspect Ratio is auto.
2. Low Blue Light
a. Off – Close Low Blue Light.
b. Low – Set Low Blue Light to Low.
c. Medium – Set Low Blue Light to Medium.
d. High – Set Low Blue Light to High.
e. Max – Set Low Blue Light to Max.
3. Response Time – This option makes panel
response time shorter.
4. FreeSync – This option support a dynamic
refresh rate aimed at reducing screen tearing.
5. HDR – This option turns on or off the HDR of the
monitor.
QHD 165Hz off 80
Panel Freq. Freesync Brightness Contrast
Auto
Input source
Type-C
Mute
Volume DP
HDMI
Reset
DP 2560x1440@165Hz
QHD 165Hz off 80
Panel Freq. Freesync Brightness Contrast
Aspect Ratio Wide Screen
Low Blue Light
4:3
Response Time 1:1
Free Sync Auto
HDR
DP 2560x1440@165Hz
18
CONNECTION
CONNECTING CABLES
50
HDMI
Connect the power cord for your monitor to the DC IN port on the back of the monitor.
Plug the power cord for the monitor into a nearby outlet. Use a connection appropriate for your computer
Using the HDMI/TYPE-C/DP connector on the video card.
50
DP TYPE-C AUDIO
19
EN
POWER