Publicidad
Idiomas disponibles
Idiomas disponibles
7
Working conditions
1.
Keep the charging temperature of the charger and battery pack between 0°C ~ 45°C, and
the battery pack discharge temperature between - 10 °C ~ 60 °C.
2.
The working temperature of the harvester - 5 °C ~ 30 °C.
Proper use of the battery charger
Before using or recharging the batteries, make sure that the battery and the battery
charger are both dry.
1.
Only use the supplied charger to charge the battery. Failure to do so may result in fire or
explosion. Use the matching charger to ensure the safety of the device.
2.
Check the charger, cord and plug before each use. If it is damaged, please have it repaired
by qualified personnel and use original parts. Do not use a defective charger and turn it on
yourself to ensure the safety of the device.
3.
The link socket of the charger must be grounded. Make sure that the power supply voltage
matches the rating of the nameplate on the charger. Otherwise, there may be an electric
shock.
4.
Disconnect the charger from the power source before closing or opening the connection to
the battery.
5.
Keep the charger clean and away from rain. Do not use the charger outdoors. The ingress of
dirt or moisture will increase the risk of electric shock.
6.
The charger can only be used to charge the original battery. If it is used for other batteries,
it may cause personal injury and cause fire.
7.
Avoid mechanical damage to the charger. Otherwise, it may cause an internal short circuit.
8.
Do not use the charger (e.g. paper, textiles) on the surface of flammable materials.
9.
If the equipment is damaged, it must be replaced by an authorized local reseller or by
Stocker Srl.
138
Art. 624
Harvester Magma E-1350 21 V
Usage
Art. 624
Harvester Magma E-1350 21 V
Usage
10. At the time of purchase, the battery of this product is not fully charged. Therefore, the user
must fully charge it before using it for the first time. Insert the battery into the base and
plug the charger into the power outlet.
11. After the battery is fully charged, unplug the charger from the power supply and the device.
Operating notes
When using this device, wear suitable clothing and work gloves. The risk
of injury can be reduced by wearing a protective device and ensuring that
the device is functioning properly.
Make sure the device is functioning properly before each use. The start/off
switch must be in working use. If the switch is loose, the power must be
turned off. If the switch is damaged, stop using the device.
Ensure that the voltage of the power supply is consistent with the voltage
on the device nameplate.
Make sure the harvester works properly to ensure that the electric scis-
sors work in an optimal state.
When the device is switched off, the rods will continue to vibrate for a few
seconds. Wait for them to stop. Do not touch or block the moving rods.
This is a source of danger!
For further information about the product, please contact info@stockergarden.com
7
139
Publicidad
