Publicidad
ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1.
Removal button
2.
Switch
3.
Turbo function button
2 stainless-steel beating whisks
4.
5.
2 stainless-steel kneading hooks
6.
Cord storage compartment
7.
Compartment for storing whisks/hooks
2 stainless-steel balloon whisks
8.
NOTE:
the graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
-
This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
Make sure all parts and components are included and in good conditions. If there is any
-
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
Whisk blender
-
-
2 stainless-steel beating whisks
-
2 stainless-steel kneading hooks
2 stainless-steel balloon whisks
-
Instruction manual
-
24
POWERTWIST 500 FULL STEEL
3. OPERATION
Assembly
-
Make sure that the switch is in the "0" position and that the appliance is unplugged.
Insert the whisks or hooks under the blender body and turn them slightly until you hear a
-
"click".
-
When placing the hooks, observe the marking next to the openings.
-
Press the removal button on the top of the blender to release the accessories.
Speed setting
-
This blender has 5 speed and a turbo mode. Speed "0" represents off setting, while speeds
"1" to "5" indicate different levels of progressive speed.
To activate turbo mode, press the turbo function button.
-
4. CLEANING AND MAINTENANCE
-
Turn off and unplug the appliance before cleaning it.
-
Remove the accessories from the blender before washing them with soap and water.
Clean the exterior only with a slightly damp cloth, making sure that no moisture gets into
-
the slots.
-
Do not clean with scouring pads or abrasive products, as this may damage the product.
-
Do not immerse it in water or any other liquid.
Storage
After cleaning, wipe the appliance with a dry cloth and store it in a dry place, for easy storage
you can wind the cable inside the cable storage.
1.
Open the lid of the compartment for storing whisks/hooks. Collect the power cable in the
compartment provided for this purpose. Fig. 2
2.
First place the kneading hooks in the compartment for storing the whisks/hooks. Fig. 3
3.
Then place the whisks in the whisk/hook storage compartment. Fig. 4
When you are going to use the blender again, first remove the whisks and hooks.
4.
5.
Fully extend the power cord and then push the lid of the storage compartment for the
whisks/hooks towards the inside of the blender.
5. TECHNICAL SPECIFICATIONS
Product reference: 04385
Product: PowerTwist 500 Full Steel
ENGLISH
25
POWERTWIST 500 FULL STEEL
Publicidad
