AEG UltraMix KM54WR Libro De Instrucciones página 7

11
Turn the Speed selector to "OFF" and unplug the appliance. Tilt the Motor head back. Use a slotted point Head
screwdriver to adjust the screw. Turn counter clockwise to raise the Attachment shaft, turn clockwise to lower it.
HOW TO USE THE MEAT GRINDER
12
How to use the Meat grinder: Insert the Grind screw (B) into the Grinder housing (A). Place the Knife (C) over the
square shaft at the end of the Grind screw. Place the Grinding plate (D) (Medium or Coarse) over the Knife.
Tighten the Ring (E) by hand until the Meat grinder is secured. Note: Do not over tighten the ring.
13
Open the Attachment hub lid on the Stand mixer. Fit the Power shaft of the attachment in the Attachment hub
socket on the Stand mixer. Rotate the attachment back and forth if necessary. Tighten the Attachment hub knob until
the attachment is fully fastened. Caution: Before attaching accessories turn off the appliance and unplug it.
14
Place the Food tray over the Grinder housing. Cut raw meat into small pieces and place it on the Food tray. Plug in
the appliance and turn the Speed selector to desired speed (recommended speed: 6-8). Feed the meat into the Feed
chute by using the Pusher. Caution: Do not put your fingers or other utensils in the Feed chute. Note: Meat should
not contain bones muscles or skin.
HOW TO USE THE SLICER/SHREDDER*
15
How to use the Slicer/Shredder: Choose a Slicer or a Shredder knife (Medium or Course). Insert the shaft (square
end) of the selected Knife into the Slicer/Shredder housing so the shaft fits into square hub socket. Secure the Knife
by pulling the Locking handle downwards. Caution: The blades and inserts are very sharp!
16
Assemble the Slicer/Shredder in the Attachment hub. Place a container under the attachment. Cut the food into
small pieces. Plug in the appliance and turn the Speed selector to desired speed (recommended speed: 8).
17
Feed the food into the Feed chute by using the Pusher. When finished using your attachment, turn off the appli-
ance and unplug it. Close the Attachment hub lid and tighten the Attachment hub knob.
CLEANING AND CARE
18
Unplug the appliance. The Wire whip, Meat grinder* and Slicer/Shredder* should only be washed by hand in warm
soapy water. The bowl, Flat beater and Dough hook are dishwasher-proof. Clean the motor unit with a damp cloth.
Caution: Never immerse the motor unit in water! Let all parts dry thoroughly.
19
Do not use abrasive cleaners or scouring pads when cleaning the appliance.
Enjoy your new AEG product!
SAFETY ADVICE
Read the following instruction carefully before using the appliance for the
first time.
• This appliance shall not be used by children. Keep the appliance and its
cord out of reach of children.
• Care shall be taken when handling the sharp cutting blades, emptying the
bowl and during cleaning.
• Appliances can be used by persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe
way and if they understand the hazards involved.
• Children shall not play with the appliance.
• The appliance may only be connected to a power supply whose voltage and
frequency comply with the specifications on the rating plate!
• Never use or pick up the appliance if
– the supply cord is damaged,
– the housing is damaged.
www.aeg.com
KM4xxx_StandMixer_AEG NO-FARSI.indd 7
GB
DE
AR
ES
FR
GR
IT
NL
PT
7
2017-07-06 13:02:06