Publicidad
Idiomas disponibles
Idiomas disponibles
Refer to Figure 1,
Check for shipping damage. If damage has occurred, a claim
must be filled with carrier. Check for completeness,
Immediately report missing parts to dealer.
The sander comes assembled as one unit. Additional parts
which need to be fastened to sander, should be located and
accounted for before assembling.
A Sander
B Work Stop
C Table
D Dust Collection Bag
E Bag Clamp
F Miter Gauge Assembly
G Handle with Washer
Not Shown: Abrasive Disc, Knob (2), Foot (4), Mounting
Bracket (4), M6 x 16 Socket Head Bolt (2). M6 x 16 Hex Head
Bolt (4), M6 Look Washer (2), M6 Flat Washer (6), M6 Hex
Nut (4). 3 and 5mm Hsx Wrench.
A
C
-'It
Figure 1 - Unpacking Sander
Refer to Figures 2 - 6.
CAUTION:
Do not attempt assembly if parts are missing.
Use this manual to order replacement parts.
WARNING:
Do not operate machine until completely assem-
bled. Do not operate machine until you have completely read
and understood this manual.
TOOLS
NEEDED
While assembling or adjusting your belt and disc sander, you
will need the following tools:
• 3 and 5ram Rex Wrenches
• Combination Square
• Phillips Screwdriver
MOUNT
SANDER
Refer to Figures 2 and 3.
Choose a suitable location to mount the sander,The sander
must be installed in a place with ample lighting and correct
power supply. To install sander:
• The sander must be bolted to a firm, level surface.
• Make sure there is plenty of room for moving the work-
piece.There must be enough room that neither operators
nor bystanders will have to stand in line with the wood
whila using the tool. Allow room so that belt assembly can
be positioned horizontally,
•
Press one foot onto each comer
of the base of the sander.
Mounting
Brackets
Figure 2 - In_rl
Mounting Brackets into Slots of
Sander Base
•
Sander
can be installed
on a workbench or a tool stand
(see Recommended
Accessories,
page 13) usir_g bolts,
lock washers
and hex nuts and mounting
brackets
(includ-
ed).
•
Figure 3 shows the base dimensions,
mounting
holes and
required space to allow for table assembly
and belt
assembly
in horizontal
position.
7"
24"
I_
!2"
18"
Figure 3 - Base Dimension and Required Space
ATTACH ABRASIVE
DISC.
Refer to Figure 4, page 4.
• Remove disc cover by loosening and removing four screws.
• Peel protective paper from the beck of the abrasive disc.
• Center the abrasive disc onto the aluminum disc and press
on firmly and evenly.
• Replace disc cover.
I
!
3
Publicidad
