Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
To choose whether the water flows from the fixed showerhead, from the handheld showerhead, or from both showerheads,
rotate the dial on the side of the diverter.
To change the spray settings, rotate the lever under each showerhead.
To operate the power washer function on the end of the handheld showerhead, press the button on the back of the handle
once for fan spray. Press the same button a second time for jet spray. Press the button a third time to return the water flow to
the face of the handheld showerhead.
CARE AND CLEANING
Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the finish
and void your warranty.
TROUBLESHOOTING
PROBLEM
There is low water pressure or
a missing spray pattern.
The shower arm/showerhead
connection is leaking.
The shower hose/
showerhead connection
is leaking.
POSSIBLE CAUSE
SOLUTION
The showerhead spray
Soak the showerhead in a solution of water and vinegar. Use a solution of 50% white
nozzles are clogged.
vinegar and 50% water overnight. The vinegar will break down any mineral deposits or
sediment from hard water and will improve the flow through your showerhead.
Debris has clogged
Remove the showerhead and rinse debris from internal parts.
the shower arm or
Turn on the hot and cold water and let it run for at least 30 seconds to flush debris
showerhead.
from the lines.
Reinstall the showerhead.
The showerhead
Gently and firmly tighten the showerhead to the diverter, but do not overtighten.
connection is loose.
The diverter connection
Gently and firmly tighten the diverter to the shower arm, but do not overtighten.
is loose.
The thread seal tape is
Remove the diverter to confirm thread seal tape was applied properly. Remove and
not creating a good seal.
reapply thread seal tape, if needed.
The handheld
Gently and firmly tighten the handheld showerhead, but do not overtighten.
showerhead connection
is loose.
5
Publicidad
