Publicidad
Idiomas disponibles
Idiomas disponibles
CHARGING THE BATTERY PACK
•
Charge the battery pack (6) before using the drill for the first time.
•
Only charge the battery (6) at ambient temperatures of 10–40°C (50–104°F).
•
Always use the power supply unit (8) supplied to recharge the battery pack. This charger is
designed to be used for the Li-ion battery in your cordless power tool.
•
Plug the PSU (8) into a 230V AC mains power source.
•
Never attempt to dismantle the battery (6).
•
To remove the battery pack (6) from the tool, push both clips (5) down and pull the battery
downwards out of the housing.
•
Only charge the battery for three to four hours.
•
Insert the charging plug from the power supply unit (8) into the battery's charging socket.
•
The red LED on the power supply unit will light up while charging.
•
Once this LED turns solid green, the rechargeable battery pack is fully charged and ready
for use.
•
Install the battery pack by sliding it into the device grip until you hear it click into place.
DISPOSING OF DEFECTIVE OR SPENT BATTERIES
Do not dispose of spent batteries in the domestic waste. According to the regulations,
you must return defective or spent batteries to local outlets or battery collection points.
Failure to do so is regarded as a misdemeanour punishable by fine.
Li-Ion
QUICK-FIT CHUCK
You can fit bits or drills into the quick-fit chuck (1) without using a chuck key.
•
Place the direction selector switch (3) into its middle position before fitting a drill or other
bits.
•
Turn ring "B" clockwise (as viewed from above or behind) and open the jaws far enough for
the bit to be inserted.
•
Insert the bit into the chuck (1) as far as it will go.
•
Turn the front part "B" of the chuck anti-clockwise and close the jaws.
•
Make sure that the bit is properly clamped into the chuck while closing it.
OPERATION
Clockwise/anti-clockwise direction of rotation
Use this switch (3) to change the direction of rotation.
•
To change the direction of rotation, stop the tool and switch the selector switch (3) into the
required position.
•
WARNING: Do not change the direction of rotation while the tool is running.
•
Before you start work, make sure that the selector switch (3) is in the right position, or you
may otherwise damage the cordless screwdriver/drill or the bit.
•
Switching the selector switch (3) to its middle position locks the on/off switch (4).
13
Publicidad
