GE 26 Manual Del Propietario Y Instalación página 18

Installation Instructions
INSTALLING THE REFRIGERATOR
(cont.)
REMOVE THE FREEZER DOOR
[] Pull the freezer door open to full extension.
[] Remove the freezer bin by pulling both brackets
upward at the same time. (See page 8.)
[] Take out the lower basket by lifting the basket up
from the rail system. (See page 10.)
[] Remove the two 10 mm hex-head bolts from the
right and left side.
REMOVE THE FREEZER DOOR (cont.)
[] Use the tip of a screwdriver to separate the rail
from the rail cover. -lilt the front end up and lift
the entire door.
[] Set the door front on a nonscratching surface.
[] Push the rail assemblies back into the cabinet.
-& CAUTION:
Push both sides of the rail
assemblies back at the same time.
REPLACING THE FREEZER DOOR
Two people may be required to complete
this procedure.
[] ATTACH AND SECURE THE DRAWER
FRONT TO THE SLIDES
[] Pull out the rail assemblies to the full length on
each side of the cabinet.
-& CAUTION:
Make sure to pull out the
side rails evenly.
18