Publicidad
Idiomas disponibles
Idiomas disponibles
The signal lamp (1-Fig.4) on the
control panel indicates correct
machine feeding.
Low water level in the tank is
indicated by the no-water si-
gnal lamp (2) and an acoustic
signal.
Turn on the general switch for
pump-heater feeding (3 Fig.4):
the temperature display (4 Fig.4)
will blink for about 4-5 seconds
and will then stabilize indicating
the internal boiler temperatu-
re. The signal lamp (2 Fig.4) will
turn on for 2 about seconds and
then will turn off.
When a temperature of about
180° is reached (visible on display
4 Fig.4) along with a pressure
value of about 10 bar (pressure
gauge 2 Fig. 2), the machine is
ready to deliver vapor.
If water is running low in the
tank, the no-water signal lamp
(2 f g.4) will start blinking along
with an acoustic signal.
Open the hatch located above
the machine to access the tank
compartment. (Fig. 5)
Two tanks are present inside the
compartment (Fig. 6). A water
tank with a capacity of 25L, and
a 5L water/detergent tank to be
f lled for more effective cleaning.
The water/detergent can must
contain only water and a mix-
ture of water and detergent.
NEVER use concentrated de-
tergents that are not diluted
with water.
English
Fig. 4
Fig. 5
Water
Fig. 6
30
Water
Water/Detergent
Publicidad
