Pro Work PFS 920 NIRO Manual De Instrucciones página 6

Anleitung PFS 920 NIRO 27.05.2004
GB
Wear goggles
Wear ear-muffs
1. Layout
11. Miter stop
12. Parallel stop
13. Wheel guard
14. Table
15. Water trough
16. Housing
17. Thumb screw
18. Scale for miter cuts
19. Knurled screw
10. Thumb screw
11. Holder for splitter
12. ON/OFF switch
13. Switch housing
14. Power cable
15. Diamond cutting wheel
16. Outer flange
17. Side cover
18. Nut
19. Splitter
2. Technical data
Motor rating: 900 W S2 10 min
Motor speed:
AC motor: 230 V ~ 50 Hz
Insulation class:
Protection type:
Length of cut:
Length of jolly:
Cutting height:
Cutting table:
- Dimensions 500 x 400 mm
- Material:
Diamond cutting wheel ø 200 x 25.4
6
9:38 Uhr Seite 6
Noise emission values
The noise produced by this tile cutting machine
is measured in accordance with DIN EN ISO
3744; 11/95, DIN EN ISO 11201: 1996-07 ISO
7960 Annex A; 2/95.
The level of noise at the workplace may exceed
85 dB(A). In this case it is essential to take
suitable precautions to protect the user's hearing
(wear ear muffs!).
Working mode
Sound pressure level LPA 92,0 dB(A)
Sound power level LWA 100,2 dB(A) 79,1 dB(A)
3. Important notes
Please read this operating manual carefully and
follow the instructions. Use the manual to familiarize
yourself with the machine, its proper use and safety
instructions.
Important!
For safety reasons it is prohibited for children, young
people under the age of 16 years and all persons
who have not read and understood the operating
instructions to use the tile cutting machine.
Portable tile cutting machine for medium tiles
Cutting performed by a diamond cutting wheel.
Jolly cuts with tilting work top up to 45 degrees.
Cutting wheel cooled with water.
2950 rpm
Straight fence and mitre fence.
Removable trough as cooling water container.
(To remove: Pull out the trough as far as the stop
Class B
and then lift slightly to remove completely.)
IP 20
unlimited
4. Intended use
unlimited
The tile cutting machine is designed to perform
41 mm
cutting jobs on small and medium tiles (floor and wall
tiles made of ceramic and similar material) which suit
the machine's size. It is intended in particular for use
by DIY enthusiasts and craftsmen. The cutting of
wood and metal is prohibited. The machine is to be
Inox steel
used solely for its intended purpose. Any use
other than its intended use is a case of mis-use. The
user/operator and not the manufacturer shall be
liable for any damage or injury resulting from cases
of mis-use. Only those cutting wheels suitable for the
machine are to be used. The use of saw blades is
prohibited. For the machine to be used as intended it
is also imperative to observe the safety instructions,
the assembly instructions and the operating
Idle
66,1 dB(A)