Power Dynamics PMP10 Manual De Instrucciones página 3

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts
are present and have been received in good condition. Notify the shipper immediately and
retain packaging material if any parts appear damaged from shipping or the package itself
shows signs of mishandling. Save the package and all packaging materials. If the product
must be returned, it is important that the product is returned in the original factory box and
packaging. If the device has been exposed to drastic temperature fluctuation (e.g. after
transportation), do not switch it on immediately. The arising condensation water might damage
your device. Leave the device switched off until it has reached room temperature.
FRONT AND BACK PANEL
1. INDICATOR LEDs
Indicator status LEDs (power, signal, clip and busy).
2. MICROPHONE INPUT
XLR input connector to connect a condenser microphone.
3. ALL
Press to (de-)select all zones.
Press and hold to lock all zones.
4. ZONE
Press to (de-)select individual zones.
Press and hold to lock individual zones.
5. CHIME
Press to turn a pre-announcement chime on/off.
6. TALK
Press and hold to allow for broadcasting on selected zones.
Release to end broadcasting.
7. LINK
Terminal to connect the main amplifier to (with UTP CAT5).
Up to 4 stations can be connected through the link-terminal.
8. CHIME VOLUME
Rotate to adjust the pre-announcement chime level.
9. OUTPUT VOLUME
Rotate to adjust the microphone volume level.
OPERATIONS
MODE
The PMP10 is equipped with both a paging- and an evacuation mode. Press and hold the CHIME button (for around 2 seconds)
to change between the two. All zone buttons will blink when the mode change is successful. In evacuation mode, the amplifier
always fully outputs (100V), even if the attenuator is set to a minimum position. The buttons of the selected zones will blink
continuously.
In paging mode, the output of the amplifier is affected by the attenuator.
TALK LOCK
Press and hold TALK (for around 5 seconds) when no zones are selected to initiate the talk lock function. When successful, the
ZONE 2 button will blink. In talk lock mode, the broadcast function is operated by "one press method". This means that instead
of pressing and holding TALK to be able to broadcast, pressing once is enough to turn the function on/off.
To turn off the talk lock function, press and hold TALK (for around 5 seconds) with no zones selected. When successful, the
ZONE 1 button will blink. Once unlocked, holding TALK is needed to be able to broadcast.
ZONE LOCK
Press and hold a zone button (for around 2 seconds) to initiate the zone lock function on that particular zone. Zone button will
be illuminated constantly. Press the zone button to unlock again.
3