Publicidad
Idiomas disponibles
Idiomas disponibles
WHEN YOU FIRST USE YOUR HEATER AND AT EVERY BOTTLE
CHANGE YOU MUST PERFORM A FULL GAS LEAK TEST OF ALL
ONCE YOU HAVE ATTACHED THE REGULATOR TO THE GAS BOTTLE
CORRECTLY AS DETAILED IN YOUR INSTRUCTION MANUAL YOU CAN
TURN THE LEVER ON THE REGULATOR TO OPEN THE VALVE ON THE
GAS BOTTLE.
THIS WILL PRESSURISE YOUR GAS HEATER.
BEFORE YOU COMMENCE THE LIGHTING SEQUENCE YOU MUST GAS
LEAK TEST ALL JOINTS AS DETAILED ABOVE USING EITHER A
SOAP/WATER SOLUTION OR PROPRIETRY GAS LEAK DETECTION
FLUID. YOU DO THIS BY APPLYING SOLUTION TO ALL THE RELEVANT
GAS JOINTS.
IF A GAS LEAK IS EVIDENT YOU WILL SEE BUBBLES APPEAR
THROUGH THE SOLUTION. IF A LEAK IS SUSPECTED TURN OFF THE
GAS SUPPLY AT THE REGULATOR AND DISCONNECT THE REGULATOR
FROM THE GAS BOTTLE IMMEDIATELY.
SEEK IMMEDIATE ADVICE FROM YOUR GAS DEALER AND DO NOT
ATTEMPT TO LIGHT THE HEATER UNTIL IT HAS BEEN CHECKED BY A
GAS ENGINEER.
4
August 2011 Rev GC01
TH
IMPORTANT SAFETY
INFORMATION
CONNECTION POINTS AS DETAILED.
1. REGULATOR TO GAS BOTTLE
2. GAS HOSE TO REGULATOR
3. GAS HOSE TO GAS VALVE
Publicidad
