asalvo baby ECUADOR 20659 Guia Del Usuario página 16

16
ADJUSTING THE HARNESS STRAPS
3
Step 1: Loosen the shoulder straps, open the
buckle.
Step 2: Pull the buckle tabs out of the chest pad
and cover and shell slots, then thread them into
the corresponding belt slots. Make sure that
both shoulder belts pass through the slots at
the same height, and that they are not twisted.
TIGHTEN THE SHOULDER RESTRAINT
4
Step 1: The shoulder straps are loosened by
pressing the lever (under the seat cover) at the
front of the seat.
EN
Step 2: Press down on the adjuster while
holding the two shoulder straps with the other
hand. Pull the shoulder straps towards you to
loosen them.
SECURING THE BABY WITH THE HARNESS
5
Step 1. Loosen the harness (see previous point), open the buckle and place
it on its side. Seat your child in the child car stroller. Place the two shoulder
straps over your child's shoulders. Note: Babies under 5 kg use the comfort
pad and the headrest pad.
If the baby weighs more than 5 kg, only the headrest pad is used.
Step 2: Place the two metal sections of the buckle connectors together, Slide
the two buckle connectors into the slot at the top of the buckle until they
"click" into place. Check that the harness is correctly locked by pulling the
shoulder straps upwards.