Buffalo CK916 Manual De Instrucciones página 4

EN
Operation
• Add water to the Water Tray if humidification is required, then place the Tray in position inside the
Merchandiser.
• Connect the Merchandiser to electricity by inserting the plug into a socket, turn on supply at socket.
• Turn switch at the rear of the Merchandiser to the on position, this will start the heating element.
• Rotate the knob at the rear of the Merchandiser to set the temperature.
• The Merchandiser is now ready for food to be displayed and kept warm.
Cleaning, Care & Maintenance
Always turn off and disconnect the appliance from the power supply before
cleaning. Always allow the appliance to cool before emptying or cleaning.
• Remove any food debris that is present in the Merchandiser after use.
• Clean the internal surfaces with a cloth that is damp with soapy water, or with a food safe cleaning
agent.
• Dry thoroughly after cleaning making sure that no moisture is left in the Merchandiser.
Removable crumb tray
• Periodically empty the crumb tray (located at
the rear of the appliance).
• Slide the tray out to empty.
• Slot back in securely when replacing the tray.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
Indicator Light The unit is not switched on
does not come on
& unit does not Plug or lead is damaged
heat up
Fuse in the plug has blown
Mains power supply fault
Thermostat has failed
Indicator Light Heating element has failed
comes on but unit
does not heat up Thermostat has failed
4
CK916_ML_A5_v5_20230928.indb 4 CK916_ML_A5_v5_20230928.indb 4
Probable Cause
Check unit plugged in correctly and switched on
Replace Plug or lead
Replace the fuse
Check mains power supply
Consult a qualified Technician
Consult a qualified Technician
Consult a qualified Technician
Crumb tray
Solution
2023/9/28 13:31 2023/9/28 13:31