Jofran 439-60T Instrucciones De Ensamblaje

j
OFRAN
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small parts
that may have come loose inside the carton during shipment.
Parts key
No Code
1 439-60T
2 439-60BP08T
3 439-60BP08B
4 439-60BP08S
5 439-60BP07
6 439-60BP02
7 439-60BP01D
8 439-60BP01F
9 439-60BP07H
10 439-60BP04
STEP 1
- Carefully place the leg on the smooth surface.
- Position the Side Panel into designated location of the leg as shown.
Insert the bolts (D) with washers (E) & (F) through pre-drilled holes
in wood cleat of Side Panel. Tighten securely with the Allen key (I).
(See Detail A).
- Do the same with other legs and Side Panel.
9
STEP 2
- Turn the Side frame (assmbled in step 1) to the upright position.
- Position the Door frame (5) onto designated location of the Side
frame as shown. Insert the bolts (D) with washers (E) & (F) through
pre-drilled holes in wood cleat of Side frame. Tighten securely with
the Allen key (I). (See Detail B).
- Insert the Top panel after positioning all the Side Frame with Door
frame as shown in Detail 2.
MADE IN VIETNAM
All manuals and user guides at all-guides.com
INC.
Qty Description
1 pc Table Top
1pc Storage Box Top Panel
1pc Storage Box Bottom Panel
2pcs
Storage Box Side Panel
2pcs Storage Box Door Frame
4pcs Legs
2pcs Door Catch Assembly
4pcs Floor Glide
4pcs Door Hinge
2pcs
Knob w/screw
Detail A
Detail B
ASSEMBLY INSTRUCTIONS &
PARTS IDENTIFICATION
MODEL # 439 - 60T/B
60" FIXED PUB TABLE
Hardware Kit (439-60BP01)
No Description Dimension
A Hex Nut ØM8
B Spring Washer Ø8x19mm
C
Øm8x13
D Allen Bolt Ø6 x 40mm
E Spring Washer Ø6.3x19
F
Flat washer Øm6.3x13
G
Knob
H
Wooden Screws Ø4x25mm
I
Allen Key
Wrench
K
STEP 3
- Turn the storage box lay down carefully.
- Insert the bolt (D) with washers (E) & (F) through pre-drilled holes
in bottom panel. Tighten securely with Allen Key (I).
STEP 4
- Carefully turn the Storage Box to the upright position.
- Position the Table top into designated locations of the Storage Box.
- Insert the hex nut with washers (B) & (C) into the fixed bolts of the
leg. Tighten securely with key wrench (K). (See Detail D)
- Affix the knob (G) to the door using screw (H), tighten screw with a
Phillips head screw driver (not provided). (See Detail E)
Detail D
Detail E
Qty.
4 pcs.
4 pcs.
4 pcs.
20 pcs.
20 pcs.
20 pcs.
2 pcs.
2 pcs.
1 pc.
1 pc.
(See Detail C)
Detail C
.