Defiant 18000010 Guía Para El Uso Y Cuidado página 5

Installation
3
Testing the push button and
doorbell
□
Temporarily position the push button (B) where
it will be mounted.
□
Press the push button (B) to verify the
doorbell (A) and push button (B) work properly.
□
If the doorbell (A) does not sound, move the
doorbell (A) closer to the push button (B) and
test again.
NOTE: Do not permanently mount the push button until
the push button and doorbell are working properly.
4
Mounting the push button
Use either screws (BB) or double-sided tape (CC) to
mount the push button (B).
□
To mount with screws (BB), remove the back
of the push button (B) by pushing in the tab
on the bottom with a small screwdriver and
twisting it. Place the push button back on the
door jamb and mark the two screw holes.
Attach with screws (BB) and snap on the front
of the push button (B).
□
When attaching the push button (B) with
double-sided tape (CC), remove the paper from
both sides of the double-sided tape (CC) and
apply to a clean surface.
NOTE: The push button and doorbell come synced from
the factory. The range of the wireless doorbell can vary
with location, temperature, and battery condition.
B
NOTE: Remove material in screw holes (if needed) before
mounting with screws.
5
Please contact 1-866-308-3976 for further assistance.
A
BB
HOMEDEPOT.COM