Urbanbiker Viena Manual De Instrucciones página 18

2- INSERT THE MUDGUARD
EN
Insert the mudguard between the fork and adjust as shown in the first picture
two of the first anchor points on both fork tubes(1). Then make the third fixing
point of the mudguard at the rear of the fork(2) match with the screw inserted
from the fixing point of the lamp (3). Check that the fastening is correct (4).
3- PLACE THE FRONT WHEEL
Place the front wheel (3) into the end (4) of the fork. Make sure that the brake
disc is placed in the centre of the brake caliper (5) so that it fits correctly. Uns-
crew the spring and pass the quick-release rod through the hole. Tighten the
axle nut (2) and pull the quick-release upwards (1).