Descargar Imprimir esta página

Craftsman WEEDWACKER 358.791820 Manual Del Operador página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

We recommend
Craftsman
brand
synthetic oil. M ix gasoline and oilata
ratio of40:1. A40:1 ratio isobtained
bymixing 3.2 ounces ofoil w ith 1
gallon o funleaded gasoline. Included
with this trimmer isa3.2 ounce
container ofoil. P our the entire
contents ofthis container
into 1gallon
ofgasoline toachieve the proper fuel
mixture. DO NOT U SE a utomotive
oilor
boat o il. T hese o ils will c ause e ngine
damage. When m ixing fuel, follow
instructions
printed oncontainer.
Once o il i sadded t ogasoline, shake
container momentarily
toassure that
the fuel i sthoroughly
mixed. Always
read and follow the safety r ules
relating tofuel b efore fueling your u nit.
IMPORTANT
Experience
indicates
that alcohol
blended fuels ( called gasohol orusing
ethanol ormethanol)
can attract mois-
ture which l eads toseparation
and
formation
ofacids d uring storage. Acidic
gas can damage the fuel system o fan
engine while i nstorage. To avoid e n-
gine problems,
empty the fuel system
before storage for30days o rlonger.
Drain the gas tank, start the engine and
letitrun until the fuel l ines a nd carbure-
torare empty. Use fresh f uel n ext sea-
son. Never use engine orcarburetor
cleaner products
inthe fuel tank orper-
manent damage may occur.
See the STORAGE
section foradditional
information.
HOW TO STOP YOUR UNIT
• Release the throttle trigger.
• To stop the engine, push and hold
the STOP switch in the STOP position
until the engine stops.
HOW TO START YOUR UNIT
_WARNING:
The trimmer head
will turn while starting the engine.
Avoid any contact with the muffler. A
hot muffler can cause serious burns.
Starting Position
NOTE:
Make sure approximately
3-4 inches (8-10
cm) of line is ex-
tended from the cutting
head before
starting unit. This will allow the line
to advance
properly once the unit
starts.
STARTING
A COLD ENGINE
NOTE: DO NOT squeeze
the throttle
trigger until the engine has started and
runs.
1. Set unit on a flat surface.
2.
Slowly press the primer bulb 6
times.
3.
Move the start lever to the START
position.
Primer
Bulb
Start
Lever
Starter Handle
4.
This unit has the Sim-pul"
starting
system. You do not have to pull the
starter rope handle sharply or brisk-
ly. Pull starter rope handle with a
controlled and steady motion until
engine starts and runs.
5.
Allow unit to run for 10-15 seconds,
then fully squeeze the throttle trigger
to disengage the starting system
(start lever returns to RUN position).
STARTING
A WARM ENGINE
1. Squeeze
and hold the throttle trig-
ger.
2.
Pull starter rope handle with a con-
trolled and steady motion while
squeezing
throttle trigger until en-
gine starts and runs.
NOTE: Normally, the warm starting
procedure
can be used within 5-10
minutes after the unit is turned OFR If
the unit sits for more than 10 minutes
without being run, it will be necessary
to start the unit by following
the steps
under STARTING A COLD ENGINE or
following
the starting instruction
steps
shown on the unit.
6

Publicidad

loading