Publicidad
Idiomas disponibles
Idiomas disponibles
®
Downdraft
MOUNT THE UNIT
MOUNTING SCREWS
1,
2,
3,
Set downdraft into opening. Extend leveling brackets to floor
of cabinet so downdraft sits straight. (Note: Leveling brackets
can be removed and re-attached
in other positions. Bottom
flange may have to face inward in tight cabinet installations.)
Secure the downdraft to the countertop as follows: Hold the
downdraft against the back of countertop cut-out and tighten-
ing the two mounting
screws
(one on each end d unit) on
underside of countertop. Use a wood shim between screw and
underside of granite countertops.
Screw leveling brackets to bottom of cabinet. Tighten screws
holding leveling bracket to unit on each side.
LEVELING BRACKET-
FLANGE FACING OUT
LEVELING BRACKET-
FLANGE FACING IN
Ventilators
Page 7
INSTALL DUCTWORK
--'_
CAUTION:
BEFORE CUTTING HOLE IN
CABINET FOR DUCTWORK,
check for interference with floor
joists, wall studs, electrical
wiring,
or plumbing.
1. Cut hole in cabinet as welt as holes in wall or floor as
necessary.
2,
Mount the roof or wall cap and work back towards the cabinet,
attaching all ductwork,
elbows
and transitions
as previ-
ously planned. Tape all ductwork connections to make them
secure and air tight.
3,
Connect ductwork
(and transition, if required) to downdraft. If
necessary, LOOSEN nuts and screws that hold the blower in
place, and slide blower
left or right to meet ductwork. Re-
tighten screws and nuts.
Note: A 3¼" x 10" collar (3¼" x 14" collar for exterior blower)
is provided for installers who prefer to rivet the ductwork to the unit.
This will allow blower to be removed and replaced easily in service
situations without disturbing ductwork.
3¼" X 10"
TO 6" RD.
TRANSITION
(3¼" X 14" TO 8"
RD. TRANSITION
FOR EXTERIOR
BLOWER
8" RD. ELBOW
DUCTWORK
Publicidad
