JBL L42ms Guia De Inicio Rapido página 2

4. Pair the Remote
5. Connect to a Network
For a Wired Connection
Connect the Ethernet port on the rear to any of the open ports on your wireless router using a CAT-5e or higher cable.
For a Wi-Fi Direct Connection
1. On your mobile device, download the JBL Premium Audio App.
2. Power on the JBL L42ms Integrated Music System.
3. Open the app to discover it after the L42ms is Ready.
4. Select it and follow the prompts to connect it to your Wi-Fi network.
5. NET icon LED will illuminate WHITE once network is enabled and connected.
Alternatively, you can connect the JBL L42ms to your Wi-Fi network using Apple Airplay Speaker Setup in the Wi-Fi settings of your
Apple device.
Turning Off Network and Bluetooth
Network and Bluetooth functionality can be turned Off should it be desired to do so. The same button operation can be used to turn
Network and Bluetooth back On.
Press "Source Selection" & "Volume +" on the top control panel simultaneously. When OFF, NET LED icon will illuminate RED color.
When ON NET LED icon will illuminate WHITE color.
Note: When the Network and Bluetooth are Off the following conditions exist:
• Speaker cannot be used for Network or Bluetooth streaming.
• The handheld remote is inoperable and the unit can only be used via the top control panel buttons.
• Network icon on top panel with show Red indicating that Network has been turned off.
L42ms QSG | Part No: xxx-xxxx-xxx | Rev 1.0 20230707
© 2023 HARMAN International Industries | Features, Specifications, and Appearance subject to change without notice.
From Top Control Panel Press &
Hold > 2 sec
Long Press > 2
sec
Press Simultaneously > 2 sec
From Remote Control Panel
Press & Hold > 3 sec
Long Press > 2
sec
EN
Pg 2 of 4