Work Pro JS-PHA0118 Instrucciones De Operación página 10

11. Viscosity Table
Examples of spray materials.
Follow the manufacturer's instructions!
Solvent-borne primers
Solvent-borne paint
Water-borne primers
Water-borne paint
Wood preservatives, stains, oils
Disinfectants
Vehicle topcoats
12. Troubleshooting Guide
Problem
No material exits
from the nozzle
Material drips
from nozzle after
spraying
Atomization too
coarse
Intermittent
(fluttering) spray
Coating pattern is
too light and uneven
The paint runs or
sags
Excessive spray
mist
Environmental protection
This product has been marked with a symbol relating to removing electric and electronic waste. This
means that this product shall not be discarded with household waste but that it shall be returned to a
collection system. It will then be recycled or dismantled in order to reduce the impact on the environ-
ment. Electric and electronic equipment can be hazardous for the environment and for human health
since they contain hazardous substances.
Possible cause
Nozzle clogged
Material tube clogged
paint volume control rotated too far
anti-clockwise (-).
Material tube is loose.
No pressure build-up in the container.
Consistency of the material is too thick.
Nozzle is loose.
Nozzle is worn.
Nozzle seal is worn.
Solids in the air cap or nozzle.
Material viscosity too high
Material volume too high
Max. paint volume control turned too
far clockwise (+).
Dirty nozzle.
Insuffcient pressure build-up in the container
Almost all of the material in the container
has been used up.
You moved the paint spray gun too fast
across the surface you are working on.
You applied too much material.
The gun is held too far away from the
object you are working on.
GB
Draining time in seconds (DIN-sec)
25-30
15-30
25-30
20-25
undiluted
undiluted
20-25
10
Solution
Clean
Clean
Turn clockwise (+)
Insert
Tighten container
Dilute
Tighten
Replace
Replace
Clean
Dilute
Turn the max. paint volume control
anti-clockwise (-)
Clean
Tighten the container
Add more
Move the gun more slowly.
Turn the max. paint volume control
anti-clockwise (-)
Hold the gun closer.
Turn the max. paint volume control
anti-clockwise (-)