Publicidad
Idiomas disponibles
Idiomas disponibles
For proper orientation of shield, see
KNOW YOUR TRIMMER illustration in OP-
ERATION section.
1. Remove wing nut from shield.
2. Insert bracket into slot as shown.
3. Pivot shield until bolt passes
through hole in bracket.
4. Securely tighten wing nut onto holt.
Bracket
q_
Slot
"_-
_\
/
w iogNut
- /
_ Gearbox
"-_fl_v
Shield
KNOW YOUR TRIMMER
READ THIS INSTRUCTIONMANUALAND SAFETY RULES BEFOREOPERATING YOUR
UNIT. Compare the illustrations with your unit to familiarize yourself with the location
of the various controls and adjustments. Save this manual for future reference.
ON/OFF Switch
_
Spark Plug
Trimmer
Head
Line Limiter
Blade
Handle
Primer Bulb
Fuel Mix
Fill Cap
Start Lever
ON/OFF SWITCH
The ON/OFF switch is used to stop en-
gine. Move switch to the OFF position to
stop engine.
PRIMER BULB
The PRIMER BULB removes air from
the carburetor
and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate the primer bulb
by pressing it and allowing it to return
to its original form.
START LEVER
The START LEVER helps to supply fuel
to the engine to aid in starting. Acti-
vate the starting system by moving the
start lever to the START position. DO
NOT squeeze the throttle trigger until
the engine has started and runs. After
the engine starts, allow the engine to
warm-up
10-15 seconds, then fully
squeeze the throttle trigger to deacti-
vate the starting system.
BEFORE STARTING ENGINE
_I, WARNING:
Be sure to read
the fuel information
in the safety rules
before you begin. If you do not
understand the safety rules, do not
attempt to fuel your unit. Call
1-800-235-5878.
FUELING ENGINE
_
WARNING:
Remove fuel cap
slowly when refueling.
This engine is certified to operate on
unleaded gasoline. Before operation,
gasoline must be mixed with a good
quality synthetic 2-cycle air-cooled
engine oil.
5
Publicidad
