Publicidad
Idiomas disponibles
Idiomas disponibles
1
2
Remove the bolt,"R" lock pin and 2 set screws from the downrod and then take down the hanger ball.
Feed the motor wire plug up through the inside of the downrod,then �ghten the 2 set screws for hanger ball firmly.
3
Bolt
2 set screws
Round plate
Nut
Warning:Failure to disconnect power supply prior to installa�on may result in serious injury.
For safety and best opera�ng results,recommend you have a qualified electrician install this fan.
Secure moun�ng bracket to outlet box by �ghtening moun�ng screws & washers.
The ceiling fan must be installed in a loca�on with a minimum of 300mm spacing from the �p of
the blade to the nearest objects or walls.Secure the moun�ng bracket to the ceiling joist or
structure that is capable of carrying a load of at least 15.9kgs,with two long screws provided.
Ensure at least 30mm of the screws is threaded into the support.
Note:For ease of wiring feed house wires through moun�ng bracket.
Moun�ng screws
X2
Insert the downrod into the coupling.
Gently push the bolt through the holes alighed with the base of the
"R" lock pin
coupling and downrod.
Insert "R" lock pin into bolt and secure downrod with 2 set screws.
CAUTION: DO NOT force the bolt.
Gently wiggle and rotate it un�l glides through both holes.
coupling
Install the blade and round plate to the motor sha� by rota�ng the nut.
Install 4 X E12 MAX.25 wa� bulbs(not included).
X4
Installation & Operating Instructions for the
Parrot uncle Owner's Installation ,Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
F8290110V
x2
Publicidad
