Publicidad
Idiomas disponibles
Idiomas disponibles
DRY IRONING.
- For dry ironing, set the steam selector to the
- You can also remove all the water from the tank.
CLEANING.
- Before cleaning the iron unplug it and wait for it to cool down.
- The remains of the base can be cleaned with a cloth dampened in a mixture
of vinegar and water.
- The remaining parts can be cleaned with a damp cloth and then dry thoroughly.
- Do not use abrasive products under any circumstances.
- Always clean after each use. The accumulation of debris can lead to damage
not covered by the warranty of the appliance. Bad use of the customer.
CALC-CLEAN FUNCTION.
- Fill the water tank to maximum and close it.
- Plug in the iron and set the temperature thermostat to maximum.
- Wait for the pilot to turn off to reach the maximum temperature.
- Holding the iron horizontally over a sink, set the selector steam in "Calc Clean" position.
- The iron will emit steam and water through the holes eliminating the impurities.
Move the iron back and forth repeatedly to facilitate the process.
- Repeat the entire process until impurities stop.
STORAGE.
- Turn the temperature controller to minimum.
- If it is plugged in, unplug the iron from the power point.
- Wait for the iron to cool.
- Drain the remaining water from the tank.
- Stand the iron upright on a firm, stable surface.
- If you wind the cable, do not force it, leave it loose a little cable, but collected.
WARNING.
USE ONLY NORMAL DISTILLED WATER.
Faults caused by tap water are not covered by the warranty.
position.
Publicidad
