Publicidad
Idiomas disponibles
Idiomas disponibles
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle during
installation.
NOTE: If your wall cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet has a front overhang.
IMPORTANT: If filler blocks are not used, case
damage may occur from over tightening screws.
NOTE: When mounting the microwave oven,
thread power cord through hole in bottom of
top cabinet. Keep it tight throughout Steps
1-3. Do not pinch
cord or lift oven
by pulling cord.
1. Lift microwave,
tilt it forward, and
hook slots at back
bottom edge onto
four lower tabs of
mounting plate.
Y
2. Rotate front of oven
up against cabinet
bottom.
3. Insert a self-aligning screw through top center cabinet
hole. Temporarily secure the oven by turning the
screw at least two full turns after the threads have
engaged. (It will be completely tightened later.) Be
sure to keep power cord tight. Be careful not to
pinch the cord, especially when mounting flush to
bottom of cabinet.
4. Attach the microwave oven to the top cabinet.
Cabinet Front
Cabinet Bottom Shelf
|
/
Filler Block
|
Equivalent to
Depth of Cabinet
Recess
~@——
Self-Aligning Screw
Microwave Oven Top
§. Insert 2 self-aligning screws through outer top cabinet
holes. Turn two full turns on each screw.
6. Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold the
microwave oven in place against the wall and the top
cabinet.)
:
7. Install grease filters. See the Owner's Manual packed
with the microwave.
13
Publicidad
