Descargar Imprimir esta página

Mi-T-M GEN-8000-iMM1E Manual De Instrucciones página 20

Publicidad

Idiomas disponibles

Idiomas disponibles

ETHANOL-BLENDED FUELS
NOTICE: Do not use E15 or E85 fuel in this product. It is a
violation of federal law and will damage the unit and void your
warranty. Only use unleaded gasoline containing up to 10%
ethanol.
ADDING FUEL
DANGER: RISK OF FIRE AND SERIOUS BURNS: NEVER
REMOVE FUEL CAP WHEN UNIT IS RUNNING. SHUT
OFF ENGINE AND ALLOW THE UNIT TO COOL AT
LEAST FIVE MINUTES. REMOVE CAP SLOWLY.
WARNING: GASOLINE AND ITS VAPORS ARE HIGHLY
FLAMMABLE
SERIOUS
PERSONAL
DAMAGE, HANDLE GASOLINE WITH CARE. KEEP
AWAY
FROM
OUTDOORS ONLY, DO NOT SMOKE WHILE ADDING
FUEL, AND WIPE UP SPILLS IMMEDIATELY.
When adding gas to the generator, make sure the unit is sitting
on a flat, level surface. If the engine is hot, let the generator cool
for five minutes before adding gas. ALWAYS fill the fuel tank
outdoors with the machine turned off.
1. Move the easy start lever to the OFF position.
2. Remove the fuel cap slowly.
3. Fill the fuel tank to 1 in. below the top of the fuel neck.
4. Replace and secure the fuel cap.
WARNING:
ALWAYS
FUELING. NEVER REMOVE FUEL CAP OR ADD FUEL
TO A MACHINE WITH A RUNNING OR HOT ENGINE.
MAKE SURE THE UNIT IS SITTING ON A FLAT, LEVEL
SURFACE AND ONLY ADD FUEL OUTDOORS. IF
THE ENGINE IS HOT, LET THE UNIT COOL FOR
AT LEAST FIVE MINUTES BEFORE ADDING FUEL.
AFTER FUELING, IMMEDIATELY REPLACE FUEL
CAP AND TIGHTEN SECURELY. MOVE AT LEAST
30 FT. FROM REFUELING SITE BEFORE STARTING
ENGINE. DO NOT SMOKE AND STAY AWAY FROM
OPEN FLAMES AND SPARKS! FAILURE TO FOLLOW
THESE INSTRUCTIONS COULD RESULT IN A FIRE
AND CAUSE SERIOUS PERSONAL INJURY.
NOTE: Always use unleaded gasoline with a pump octane rat-
ing of 86 or higher. Never use old, stale, or contaminated
gasoline, and do not use an oil/gas mixture. Do not allow
dirt or water into the fuel tank. Do not use E85 fuel.
HIGH ALTITUDE OPERATION
Your engine is configured for operation below altitudes of
3,000 feet at the factory. Your engine must be reconfigured
for operation above the preconfigured altitude. Operating the
engine with the wrong engine configuration at a given altitude
may increase its emissions, decrease fuel efficiency, degrade
performance, and cause irreversible damage. Engines config-
ured for high altitude operation cannot be operated in standard
altitude conditions. A qualified service center should ensure that
your engine is properly configured for your location.
20
PREPARING THE GENERATOR
AND
EXPLOSIVE.
TO
INJURY
AND
IGNITION
SOURCES,
SHUT
OFF
ENGINE
PREVENT
PROPERTY
HANDLE
BEFORE
Operator's Manual

Publicidad

loading