MPM MOD-39 Manual De Instrucciones página 17

BEFORE FIRST USE
1. Take the vacuum cleaner out of the packaging, remove all stickers, shipping locks, bags and fillers.
2. Check the vacuum cleaner for any damage that may have occurred during transport. Contact your
retailer if you suspect damage.
3. Assemble the vacuum cleaner correctly (see chapter: „ASSEMBLING (DISASSEMBLY) OF THE
VACUUM CLEANER").
4. Make sure that the parameters of your power supply correspond to the data on the rating plate
of the device.
ASSEMBLY (DISASSEMBLY) OF THE VACUUM CLEANER
1. Insert the tube (3) into the latch (6) and close the latch.
2. Install the selected brush on the end of the tube in the dust container (4).
USING THE DEVICE
1. Make sure the vacuum cleaner is properly assembled, the filters are in place.
2. Choose the most suitable accessories for your cleaning tasks. For the most effective cleaning, use
the following accessories:
- floor brush (5) - vacuuming carpets and hard surfaces such as stoneware or terracotta
- crevice attachment (8) - vacuuming in hard-to-reach places.
- small multifunctional brush (9) – vacuuming curtains, upholstery, clothing, furniture, blinds.
3. Insert the plug of the vacuum cleaner into the power socket and turn on the device with the
switch (1).
ATTENTION! The device is only intended for vacuuming dry surfaces!
4. Check the filling level of the dust container (4) on an ongoing basis, if it is full, stop vacuuming and
empty the dust container. Working with an overfilled container reduces the efficiency of vacuum-
ing (reducing the centrifugal force that throws impurities into the container) and leads to premature
clogging of the filters.
5. If during operation you notice a clear decrease in suction power and
the dust container is empty, be sure to check the patency and the
currently used equipment.
6. Depending on your needs, you can use the vacuum cleaner without
the tube (3) with the handle (4)
dimensions of the vacuum cleaner and thus you can vacuum hard-
to-reach places.
7. After finishing vacuuming, turn off the device with the switch (1) and
then disconnect it from the mains.
EMPTYING THE DUST CONTAINER
1. Turn off the vacuum cleaner with the switch (1) and disconnect it
from the power source.
2. Open the vacuum cleaner with the button (7) and empty the dust into the garbage.
CLEANING AND MAINTENANCE
1. Clean the outer surfaces of the vacuum cleaner, the inside of the dust container and accessories
with a damp cloth and then wipe them dry. For heavy soiling, use a mild detergent.
. In this way, you reduce the
fig. 1
EN
fig. 1
17