Deltaco WM90 Manual Del Usuario página 5

ENG
1. Left button
2. Right button
3. Wheel button
4. Forward button
5. Backward button
6. DPI button
7. On/off button
8. LED mode button
DPI
Use the DPI button to change the DPI. The DPI can
also be changed via the software.
USB Polling rate
The default polling rate is set to 1000 Hz.
You can switch polling rate between 125 Hz and 1000
Hz by pressing and holding the wheel button (3.) and
backward button (5.) for 3 seconds. Red LED = 1000
Hz. Green LED = 125 Hz.
You can adjust the polling rate via the software to:
125Hz / 250Hz / 500Hz / 1000Hz.
LED light
Press and hold the LED mode button for 3 seconds to
turn on or turn off the LED lights.
Short press changes the LED mode.
Power features
The mouse will enter sleep mode after 10 minutes.
Press any key to wake up the mouse.
When you move the mouse the LED lights turn off
automatically.
Low battery: When battery has less then 30 % left,
the LED flashes red rapidly. When the battery has
less then 10% left, the mouse will automatically
power off.
While charging: When battery is 30-90% charges, the
LED flashes yellow, when it is 90%-100% charged, it
is static green.
Pairing
The mouse and receiver have been paired at factory.
Pairing might still be needed.
To pair: Press and hold left button + right button +
wheel button for 1 second.
The LED will flash yellow. Insert the receiver on a PC.
The pairing is now successful.
Software
Download the software at
www.deltacogaming.com
Cleaning
Clean the product by using a dry cloth.
Safety instructions
1. Keep the product dry. Keep it away from all liquids.
This product is not waterproof.
2. Do not open up or try to repair the product by
yourself.
3. Keep the product and packaging out of reach of
children to prevent accidents and choke hazards.
4. Do not drop or expose to shock damage.
Warranty
Please, see www.deltaco.eu for warranty infor-
mation.
Support
More product information can be found at
www.deltaco.eu.
Contact us by e-mail: help@deltaco.eu.
5