Publicidad
Idiomas disponibles
Idiomas disponibles
Exchange the use of the start key for
starter handle, Pull starter handle quickly.
Do not allow starter rope to snap back.
• To stop engine, release operator
presence control bar°
NOTE:
In cooler weather it may be
necessary
to repeat priming steps.
In
warmer weather over priming may
cause flooding and engine will not
start,
tf you do flood engine wait a few
minutes before attempting
to start and
do not repeat priming steps,
MOWING
TIPS
• Under certain conditions, such as very tall
grass, it may be necessary to raise the
height of cut to reduce pushing effort and to
keep from overloading the engine and
leaving clumps of grass clippings.
= For extremely heavy cutting, reduce the
width of cut and raise the rear of the lawn
mower housing one (1) wheel adjuster
settinghigher than the front for better
discharge of grass.
o When using a rear d_scharge lawn mower in
moist, heavy grass, clumps of cut grass
may not enter the grass catcher. Reduce
ground speed (pushing speed) and/or run
the lawn mower over the area a second
time.
• tf a trail of grass clippings is left on the dght
side of a rear discharge lawn mower, mow
in a clockwise direction with a small ovedap
to collect the clippings on the next pass.
, Keep top of engine around slarter clear and
clean of grass clippings and chaff. This will
help engine air flow and extend engine life.
• Pores in cloth grass catchers can become
filled with dirt and dust with use and
catchers will collect less grass. To prevent
this, regularly hose catchers off with water
and let dry before using.
MULCHING
MOWING
TIPS
IMPORTANT:
For best performance, keep
mower housing free of built-up grass and
trash. See "Cleaning" in Maintenance section
of this manual.
- The special mulching blade wil! recur the
grass clippings many times and reduce
them in size so that as they fall onto the
lawn they will disperse into the grass and
notbe noticed, Also, the mulched grass wilt
biedegrade quickly to provide nutrients for
the lawno Always mulch with your highest
engine (blade) speed as this will provide the
best recutting acl_on of the blades.
• Avoid cutting your lawn when it is wet° Wet
grass tends to form Clumps and interferes
with the mulching action. The best time to
mow your lawn is the early aftemoon_ At
this time the grass has dried and the newly
cut area will not be exposed to the direct
sun,
• For best results, adjust the lawn mower
cutting height so that the lawn mower cuts
off only the top one-third of the grass blades.
If the lawn is overgrown itwilt be necessary
to raise the height of cut to reduce pushing
effort and to keep from overloading the
engine and leaving clumps of mulched
grass_ For extremely heavy mulching,
reduce your width of cut by overlapping
previously cut path and mow stowiy_
• Certain types of grass and grass conditions
may require that an area be mulched a
second time to completely hide the
clippings, When doing a second cut, mow
across or perpendicular to the first cut path.
• Change your cutting pattern from week to
week. Mow north to south one week then
change to east to west the next week. This
will help prevent matting and graining of the
tawno
Max !/3
9
Publicidad
