Crosley C62B-WA Manual De Instrucciones página 6

English
Bluetooth Operation
1. Turn the Function Knob to Bluetooth mode , you will hear an activation sound from the unit.
2. Turn on the Bluetooth feature of your audio device, search for "Crosley C62B" and pair.
3. Once your device is successfully paired with the unit, you will hear a short confirmation sound from the unit.
4. Play and stream music from your device to the unit.
Note: Bluetooth version - *5.0*
Turntable Operation
1. Press the Power Switch to turn on the power.
2. Set the Function Knob accordingly.
3. Place the record on the turntable. Use the 45 RPM Adapter if necessary.
4. Remove the stylus protector from the stylus assembly.
Note: To avoid stylus damage, make certain the included stylus guard is in place whenever the turntable is being moved or cleaned.
5. Release the tonearm Hold Down Clip.
Note: when the turntable is not in use, remember to lock back hold down clip.
6. Use the Cue Lever to lift up the tonearm.
7. Gently move the tonearm over the record where play is desired to begin. Set the Cue Lever back to the down position,
the tonearm will descend slowly onto the record and begin to playback.
8. When the record is finished playing, use the Cue Lever again to raise the tonearm and then return it to the Tonearm
Rest. Release the lever to let the tonearm sit back at its rest. To suspend the playback, repeat the same steps.
9. Lock the Hold Down Clip to secure the tonearm.
Anti-Skate Adjustment
• A small outward "anti-skating" force can be applied to the tone arm to compensate for the "skating" force that pulls
the arm toward the center of the record.
• For best performance during normal turntable usage, it is recommended to set the anti-skate control knob to the
same value as indicated by the downforce scale dial.
Platter Auto-stop
If the Auto-stop Switch is set to ON position, the platter will stop spinning automatically when the record plays to the end.
In some rare occasion, if the turntable stops playing before the end of the record, set the switch to OFF position the
turntable should overcome this issue.
Cartridge Replacement
1. Before replacement, put the stylus protector back on the stylus to prevent damage to the stylus during the
replacement process.
2. Carefully remove the wire leads from the original cartridge.
3. Loosen the two screws on the headshell that are securing the cartridge and then remove the original cartridge.
4. Mount the new cartridge to the headshell and tighten it lightly. Do not completely tighten the screws at this moment.
5. Connect the wire leads to the new cartridge's terminals .The wire lead color codes are as below:
White
Black
Red
Black
6. Adjust the cartridge's position to make sure it is precisely aligned on the headshell so that the stylus will be
tracking the grooves in parallel perfectly.
To achieve this, place the included paper cartridge alignment protractor over the turntable spindle, carefully lift the
tone arm and place the tip of the stylus on the points marked 130mm and 250mm respectively. Fine tune the
cartridge's position on the headshell until the cartridge is perfectly in parallel with the reference lines at both points.
7. Tighten the screws completely once the perfect alignment is achieved.
Left channel positive
Left channel negative
Right channel positive
Right channel negative
(L+)
(L–)
(R+)
(R-)
6