Buffalo K335 Manual De Instrucciones página 8

UK
If the circuit breaker stops the appliance or the appliance becomes jammed:
Turn Off the appliance immediately.
1.
Press the RESET button located at the back of the appliance above the power cord.
2.
Turn and HOLD the switch in the reverse position to clear the blockage.
3.
Remove and clear the mincing barrel and all components.
4.
Cleaning, Care & Maintenance
Note: Always switch off and disconnect the appliance from the power supply before
cleaning.
• Do not use any abrasive cleaning agents on the appliance. Use warm soapy water.
• Do not immerse the motor housing in water. Clean the exterior with a damp cloth.
• Always dry thoroughly after cleaning.
• A BUFFALO agent or qualified technician should carry out repairs if required.
For ease of cleaning, disassemble the appliance:
• Unscrew the barrel cap.
Note: If the cap has been put on too tight, knock the corners of the cap with a rubber
mallet or similar instrument to loosen it.
• Remove the mincing barrel, plate, blade and feed screw as one unit. Gently tip the barrel to remove
the pieces one by one.
• Twist off the hopper tray.
• Remove meat from all components and wash in warm, soapy water.
• Dry thoroughly.
• Lubricate the parts with a little cooking oil before replacing for best performance.
Troubleshooting
If your BUFFALO appliance develops a fault, please check the following table before making a call to the
Helpline.
Fault
The appliance is not working
3
Probable Cause
The appliance is not switched
on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Action
Check the appliance is plugged in
correctly and switched on
Call BUFFALO agent or qualified
technician
Replace the plug fuse
Check power supply
Call BUFFALO agent or qualified
technician