Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT SPECIFICATIONS
SPECIFICATIONS
Max. flow rate: 1.8 GPM (6,814 LPM) at 60 PSI
ASME A112.18.1/CSA B125
NSF 61-9
Chrome and stainless steel
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply
valve under the sink or at the
main water supply, disconnect
the supply line, and remove old
faucet.
Clean and dry surface area where
new faucet will be mounted.
2. Insert spout into body making
sure the O-ring (2.1) snaps into
place. Hand tighten spout nut
(2.2) over body threads.
3. Screw flanges onto the fine
thread side of swivel unions, flat
side facing away from faucet.
Use a wrench (not included) to
tighten swivel unions onto 1/2 in.
stub out pipes extending from
the wall. Insert rubber washer
into union nuts, then fasten to
body using union nuts attached
to the body.
Note: Do not overtighten.
www.homewerksww.com
1
2
2.2
2.1
3
SPECIFICATIONS
Ceramic cartridges
Manufactured to include no more than 0.25% weighted average lead
content on wetted surfaces
Total weight of item: 5.75 lbs.
4.
Attach spray head to goose-
neck hose. Hand tighten.
5.
Re-connect supply lines. Turn
water supply or shut-off valve
back on and check for leaks. If
leaks occur, gently tighten union
nut and swivel union until leaks
stop.
6.
IMPORTANT: Remove the
spray head by unscrewing it
from the goose neck hose in
a counterclockwise direction.
Be sure to hold the end of the
goose neck hose down into
the sink and turn the faucet on
to the warm position, where
it mixes hot and cold water.
Check for leaks. Re-tighten any
connections if necessary but do
not overtighten. Reinstall the
spray head by hand tightening it
back onto the goose neck hose.
2
4
5
6
Publicidad
