Tesla IR200R Manual De Instrucciones página 5

ANTI DRIP
1. Anti-drip system, which is designed to prevent water
escaping from the soleplate when the iron is too cold
automatically.
2. During use, the anti drip system may emit a loud clicking
sound, particularly during heat-up or whilst cooling down.
This is perfectly normal and indicates that the system is
functioning correctly.
Temperature and steam settings table
Instructions on Label
CLEANING AND MAINTENANCE
Before cleaning, remove the plug from the socket and allow the iron to cool down sufficiently.
1. Wipe off the soleplate with a damp cloth and a non-abrasive (liquid) cleaner.
2. If the fiber is adhered to the soleplate, use a damp cloth with vinegar to wipe off the soleplate.
3. Never use strong acid or alkali in order to avoid damaging the soleplate.
4. If the scale blocks the steam hole, please remove the scale with toothpick; do not damage the surface of soleplate.
5. Stand the iron on its end and let it cool down sufficiently, and meantime pour any remaining water out of the box, set
the steam knob to position "O".
Simple Repair Methods
Problem
Not enough heat or Too heat
No steam or Leakage
No burst of steam or no
vertical steam
Leaking water from Soleplate
Little Steam
No Spraying
Caution:
Possible Reasons
Rotate thermostat dial improperly or
unplugging
The thermostat dial has been set to MIN
The (vertical) burst of steam function has
been used too often within a very short
period. The iron is not hot enough
Set the thermostat dial out of steam range.
The heat is still not enough.
The water is over than max position
Check if the steam selector is in proper
location.
Steam hole is blocked.
Too little water in the water tank
No enough pressure or air inside
ANTI SCALE
The build-in anti-scale cartridge is designed to reduce the
build-up of limescale which occurs during steam ironing.
This will prolong the working life of your iron. However,
please note that the anti-scale cartridge will not completely
stop the natural process of limescale build-up.
Indicates that the fabric is not ironing
Type of Fabric
Nylon
Silk
Wool
Cotton
Linen, jeans
Thermostat Dial
MIN
MAX
Measurement
Correct Thermostat dial in position and
check if the iron is plugged.
Set the thermostat dial to the required
positioin.
Continue ironing in horizontal position and
wait a while before using the (vertical) burst
of steam function again
Set the thermostat dial as per steam range.
Open steam button only after the indicator
light goes off.
Pour out the remaining water
Set the steam selector to the proper
location.
Clean hole with distilled water.
Fill water into the box
Press the spray nozzle by hand, and push
the spray button several times continuously.
5