Arrow STROOT Manual De Usuario Y Garantía página 18

EN
•
Do not circulate in puddles of water deeper than 4cm.
•
Do not use this product in an environment with a temperature lower than
-5ºC.
•
The E-Scooter is a means to move individually. Our technology and pro-
duction processes are developed and verified with very strict tests for
each E-Scooter.
•
Running the E-Scooter, without following the instructions at this manual,
can damage the product, or cause injury.
E-SCOOTER MAINTENANCE
Read this information carefully to keep your E-Scooter up to date.
Each time you use your E-Scooter, we recommend you to keep the wheels,
axles, steering, handlebars, handlebar folding lever and display, clean and dry
(do not wet or clean with abrasive liquids).
Avoid getting your E-Scooter wet, this will result in the loss of warranty.
The tyre should be replaced when there is any sign of wear or breakage, on this
case you have to contact with the distributor to replace the original tyre-cover.
This scooter incorporates a braking system with wearing parts, such as brake
pads and brake discs. Monitor its condition, and if it's necessary, visit an official
center for the replacement.
Check the scooter for loose screws. If any are loose, tighten them.
Do not place scooters in the sun or other several wet places for a long time;
please keep the scooter clean.
Keep the rear brake disc clean to avoid breakage.
Warning: Do not use alcohol, gasoline, kerosene, volatile chemical solvents or
other corrosive solutions to clean the vehicle. Failure to do so will cause serious
damage to the structure and/or internal elements. Do not wash the electric
scooter under strong water pressure, even if the scooter is switched off.
CHARGING AND MAINTENANCE OF THE LITHIUM BATTERY
Before using your E-Scooter for the first time, we recommend that you fully charge the
battery: connect the charger to your E-Scooter via connector on the left side of the scooter
base and plug the charger into the power supply. Do not disconnect the equipment until the
battery is fully charged. The battery display indicates the battery charge.
The charging time of the battery depends on the amperage of each battery
and can take up to 5 hours.
18