Publicidad
Idiomas disponibles
Idiomas disponibles
USING YOUR TAMPER INCL. PB2B-P1200
The tamper is to be used for stirring food and reading the food temperature in
the blender jar.
Never use the tamper without the lid in place. Remove the filler cap from the lid
and slide tamper into the Blender Jar. The tamper has a splash guard located
near the top that prevents the tamper from coming in contact with the blade
assembly.
The maximum temperature for the tamper is 212ºF. To take a temperature
reading simply press the temperature button located on top of the tamper. The
temperature is read by a sensor located at the bottom of the tamper.
You can turn the temperature sensor off by pressing the temperature button;
otherwise it will automatically shut off after 2 minuttes. To change between
Celsius and Fahrenheit press the button on the top of the tamper for more than
3 seconds.
CHANGING THE TAMPER BATTERY
1. Open the Top Cover by turning
counterclockwise.
2. Remove the PCB Assembly from the Tamper
being careful not to pull the wire connector.
3. Locate the battery on the underside of the
PCB Assembly. Slide out the battery from
under the bracket. Slide a new battery into
the bracket and replace the PCB Assembly
and Top Cover. Use only battery type
CR2032.
1.
Temperature Button
2.
Top Cover
3.
PCB Assembly
4.
Battery
5.
Decorative Ring
6.
Handle
7.
Splash Guard
8.
Tamper Stem
9.
Temperature Sensor
(located underneath)
BLENDER · PB2B-P1200
➊
9
EN
➋
➌
➍
➎
➏
➐
➑
➒
Publicidad
