NORTH STATES 8693 Instrucciones página 4

Step 4
To attach the hinge side of the gate to the mounting sockets, refer to Figure 4. Note, to align the hinge posts over
the mounting sockets, the gate must be at a 45-90 degree angle to the plane of the opening. Once the hinge
posts are aligned over the mounting sockets (Figure 5), set the gate into place. The gate can be removed from
the opening by reversing this procedure.
STAIRS
SIDE
FIGURE 4
Check to see that the release handle is positioned properly (Figure 6). If not, simply depress the locking tabs to
release the handle, this may require slight force. Move the handle to the top side of the gate and snap it into
place on the locking tabs.
NOTE: When installing the gate, the release handle must be on the side away from pet.
SIDE
Operating the Gate
TO CLOSE GATE
FIGURE 7
CLEANING INSTRUCTIONS: Wash with warm water using mild liquid soap. Use a soft cloth to avoid
scratching the gate. Rinse with clear water and wipe dry with a soft cloth. NOTE: Never use solvents,
chemicals, scouring powders or sharp tools when cleaning the gate.
AT LEAST
HANDLE
HANDLE
FIGURE 6
To lock the gate, align the locking pegs
over the mounting sockets (Figure 7)
and set the gate into place. Make sure
that each time you use the gate, both
the top and bottom locking pegs are set
into the mounting sockets. Test your
installation by pulling up on both the
hinge and locking sides of the gate to
make sure you can't dislodge either side.
To unlock the gate, pull back on the
release handle (and the panel it is
attached to) until the release handle
clears the mounting socket. Then lift the
gate panel until the locking pegs clear
the sockets (Figure 8).
FIGURE 5
TO OPEN GATE
FIGURE 8
Page 4
SIDE